3.1.2 Matrix Server Upgrade Guide

Chapter 4: Double Upgrade Procedures 48

26. Repeat steps 23 through 25 until all of the nodes have been upgraded.

27. On the node that was upgraded first, run the following command:

# ./mxfsmigrate.sh --end

All servers in the matrix are now running Matrix Server 3.1.2 in 32-bit

mode. Next, repeat the rolling upgrade as described in the following

steps.

28. Disable the server to be upgraded (start with the server with the

highest IP address). Right-click on the server and select Disable.

29. Back up the Matrix Server configuration again on the server to be

upgraded. Use tar -cv to create tar files of the /etc/opt/polyserve and

/var/opt/polyserve directories.

30. Stop Matrix Server on the server:

# /etc/init.d/pmxs stop

31. If you will be performing a fresh installation of the 64-bit operating

system, skip to step 35. Otherwise, continue with the following steps.

32. Uninstall MxFS-Linux 3.1.2 from the server. Run the following

commands:

# rpm -e mxfs

# rpm -e mxfs-sles9-support

# rpm -e mxfs-patches

33. Uninstall Matrix Server 3.1.2 from the server. This step does not

remove your existing matrix configuration or log files. The matrix

software must be uninstalled from a location outside of the matrix

directory structure (/opt/polyserve).

Run this command on the server:

# rpm -e pmxs

The following message then appears:

Stopping PolyServe Matrix Server

This server needs to be rebooted before the product removal

can proceed.

/etc/init.d/pmxs has been moved to /etc/init.d/Pmxs to avoid