3.1.2 Matrix Server Upgrade Guide

Chapter 4: Double Upgrade Procedures 46

The following message then appears:

Stopping PolyServe Matrix Server

This server needs to be rebooted before the product removal

can proceed.

/etc/init.d/pmxs has been moved to /etc/init.d/Pmxs to avoid

PolyServe Matrix Server from starting automatically on boot.

error: %preun(pmxs-<ver>-release) scriptlet failed, exit status 1

Reboot the server and run the rpm -e command again. Matrix Server

will now be uninstalled.

NOTE: When the uninstall is complete, you will see a message listing

files and directories that could not be removed. Do not

manually remove any of these files.

10. Uninstall the Management Console:

# rpm -e mxconsole

11. Upgrade the operating system to 32-bit mode SLES9 SP2 or do a fresh

installation. (See Appendix B for information about files that need to

be modified.)

12. Install the Matrix Server Support RPM (use the 32-bit version) and the

MxFS-Linux kernel patches RPM and then compile the kernel and

reboot. Be sure to verify that the kernel is patched correctly for MxFS-

Linux. See Appendix B for more information.

13. If you did a fresh installation of the operating system, extract the

backup tar files saved in step 2 to /etc/opt/polyserve and /var/opt/

polyserve.

14. Install Matrix Server 3.1.2 from the Matrix Server product CD or the

location where you have downloaded the software. Be sure to install

the 32-bit version of the RPM.

# rpm -i <mountpoint>/pmxs-3.1.2-<xxxx>.i586.rpm

15. Install the Management Console:

# rpm -i <mountpoint>/mxconsole-3.1.2-<xxxx>.i586.rpm