3.1.2 Matrix Server Upgrade Guide

Chapter 4: Double Upgrade Procedures 32

/etc/opt/polyserve/mxinit.conf

/etc/opt/polyserve/scl.conf

/etc/opt/polyserve/fc_pcitable

/etc/opt/polyserve/san_snmp.conf

4. If you will be performing a fresh installation of the operating system,

skip to step 9. Otherwise, continue with the following steps.

5. If the Matrix Server Support RPM is installed, uninstall it:

# rpm -e pmxs-<os>-support

6. Uninstall any Matrix Server patches installed on the server:

# rpm -e pmxs-patch

7. Uninstall Matrix Server 3.1.x from the server. This step does not

remove your existing matrix configuration or log files. The matrix

software must be uninstalled from a location outside of the matrix

directory structure (/opt/polyserve).

Run this command on the server:

# rpm -e pmxs

The following message then appears:

Stopping PolyServe Matrix Server

This server needs to be rebooted before the product removal

can proceed.

/etc/init.d/pmxs has been moved to /etc/init.d/Pmxs to avoid

PolyServe Matrix Server from starting automatically on boot.

error: %preun(pmxs-<ver>-release) scriptlet failed, exit status 1

Reboot the server and run the rpm -e command again. Matrix Server

will now be uninstalled.

NOTE: When the uninstall is complete, you will see a message listing

files and directories that could not be removed. Do not

manually remove any of these files.

8. Uninstall the Management Console:

# rpm -e mxconsole