3.1.2 Matrix Server Upgrade Guide

Chapter 3: Single Upgrade Procedures 16

14. If you did a fresh installation of the operating system, recreate mount

points for the PSFS filesystems.

15. Start Matrix Server on the upgraded server. Run the following

command:

# /etc/init.d/pmxs start

16. Repeat this procedure on each server in the matrix.

The upgrade is now complete.

Matrix Server 3.1.x With MxFS-Linux

Complete the following steps to upgrade to Matrix Server 3.1.2.

NOTE: Upgrade the server with the highest IP address first. Then

continue to upgrade the servers in descending order of IP address,

with the lowest numbered server being upgraded last.

1. Disable the server to cause any active Virtual NFS Services to migrate

to another server. (Right-click on the server and select Disable).

2. Back up the Matrix Server configuration on the node being upgraded

as described under “Back Up the Existing Matrix” on page 2.

3. Stop Matrix Server on the server:

# /etc/init.d/pmxs stop

4. If the following Matrix Server configuration files have been modified

at your site, save copies of the files. After installing Matrix Server, you

can merge your local changes into the new versions of the files.

/etc/opt/polyserve/mxinit.conf

/etc/opt/polyserve/scl.conf

/etc/opt/polyserve/fc_pcitable

/etc/opt/polyserve/san_snmp.conf

5. Remove any MxFS-Linux patches:

# rpm -e mxfs-fastpatch