3.1.2 Matrix Server Upgrade Guide

Chapter 2: “All-at-Once” Upgrades 8

12. Install Matrix Server 3.1.2 from the Matrix Server product CD or the

location where you have downloaded the software. Be sure to install

the RPM that corresponds to your architecture (i586 for 32-bit or

x86_64 for 64-bit).

# rpm -i <mountpoint>/pmxs-3.1.2-<xxxx>.<arch>.rpm

13. If you saved any Matrix Server configuration files in step 3, compare

the saved files with the new versions of the files that were installed

with Matrix Server 3.1. (The new versions were installed in the

directory /etc/opt/polyserve.) You will need to migrate your customized

values from the old files to the new files as necessary.

14. Install the Management Console:

# rpm -i <mountpoint>/mxconsole-3.1.2-<xxxx>.i586.rpm

15. Copy your new license file to /etc/opt/polyserve/licenses/license.

16. Start Matrix Server. Run the following command:

# /etc/init.d/pmxs start

The upgrade is now complete.

Upgrade With MxFS-Linux

Complete the following steps on all servers in the matrix:

1. Back up the Matrix Server configuration as described under “Back Up

the Existing Matrix” on page 2.

2. Stop Matrix Server:

# /etc/init.d/pmxs stop

3. If the following Matrix Server configuration files have been modified

at your site, save copies of the files. (For Matrix Server 3.1.0 and later,

the files are in /etc/opt/polyserve.)

/etc/polyserve/mxinit.conf

/etc/polyserve/scl.conf

/etc/polyserve/fc_pcitable

/etc/polyserve/san_snmp.conf