3.1.2 Matrix Server Administration Guide

Chapter 6: Configure Dynamic Volumes 77
Copyright © 1999-2006 PolyServe, Inc. All rights reserved.
When the dynamic volume has been created, the Management Console
reports the psv name assigned to the volume. On the Management
Console, filesystems are identified with the psv name of the dynamic
volume on which they are located, as shown below.
To create a dynamic volume from the command line, use the following
command:
mx dynvolume create [--stripesize <4KB-64MB>]
<subDeviceName,subDeviceName,...>
The following command lists the available subdevices:
mx dynvolume showcreateopt
Dynamic Volume Properties
To see the configuration for a dynamic volume, select Storage > Dynamic
Volume > Volume Properties and then choose the volume that you want
to view. If a filesystem is associated with the volume, the Volume
Properties window shows information for both the dynamic volume and
the filesystem.