HP StorageWorks 1/8 Tape Autoloader User and Service Guide (August 2005)

1/8 Tape Autoloader User and Service Guide 73
B Regulatory compliance notices
This appendix contains regulatory notices for the HP StorageWorks 1/8 Tape Autoloader.
Regulatory compliance identification numbers
For the purpose of regulatory compliance certifications and identification, this product has been
assigned a unique regulatory model number. The regulatory model number can be found on the
product nameplate label, along with all required approval markings and information. When
requesting compliance information for this product, always refer to this regulatory model number.
The regulatory model number is not the marketing name or model number of the product.
Product specific information:
Regulatory model number: BRSLA-0203
FCC and CISPR classification: Class B
Regulatory compliance label location
The Regulatory Compliance label for the HP StorageWorks 1/8 Tape Autoloader is located on the
bottom of the autoloader. To view this information, carefully turn the autoloader until the regulatory
compliance label is visible.
Power cords
WARNING! This product can ONLY be used with an HP approved power cord for your specific
geographic region. Use of a non-HP approved power cord may result in: 1) not meeting individual
country specific safety requirements; 2) insufficient conductor ampacity that could result in
overheating with potential personal injury and/or property damage; and
3) an unapproved power cord could fracture resulting in the internal contacts being exposed,
which potentially could subject the user to a shock hazard. HP disclaims all liability in the event a
non-HP approved power cord is used.
The power cord included with the HP StorageWorks 1/8 Tape Autoloader meets the requirements
for use in the country where this product was purchased. If this tape library is to be used in another
country, purchase an HP-approved power cord that is approved for use in that country.
The power cord must be rated for the product and for the voltage and current marked on the
product electrical ratings label. The voltage and current rating of the cord should be greater than
the voltage and current rating marked on the product. In addition, the diameter of the wire must be
a minimum of 1.00 mm
2
or 18 AWG. If you have questions about the type of power cord to use,
contact an HP authorized service provider.