HP StorageWorks 1/8 Tape Autoloader User and Service Guide (August 2005)

1/8 Tape Autoloader User and Service Guide 57
8. Carefully pull the cartridge lock release lever as shown in Figure 20 away from the cartridge
carrier allowing the cartridge to slide out of the carrier.
Figure 20 Pull cartridge lock release lever
9. After removing the cartridges from the desired carriers, reinstall each carrier by placing it on
the belt and rotating it clockwise until the tab engages with the belt.
• Make sure that the rollers on the bottom of the carrier are aligned in the carrier tracks.
• Make sure that the belt tab beneath each carrier is inserted into the proper autoloader belt
loop.
NOTE: There are unused loops on the belt. The proper belt loops have an extra bump on the
outside of the loop (see Figure 19 on page 56).
10.Ensure the carrier is properly installed on the belt by gently pressing on the top of the carrier
and sliding it back and forth. If it is properly attached to the belt, it should not move. If the
carrier moves, reinstall the carrier.
11.Replace the top cover of the autoloader and reinstall the eleven cover screws and mounting
brackets.