HP StorageWorks 1/8 Tape Autoloader User and Service Guide (August 2005)

Autoloader administration44
View error log or event log
This option provides access to the most recent autoloader errors and events (see Table 20 on
page 59 for a description of error codes). This information is stored in the error log (Ultrium 232,
Ultrium 448 and Ultrium 960 models) or event log (all other models).
To use this option:
1. From the Home screen or Main menu, press + or - until Information displays on the top
line of the LCD screen. Press Enter to access the available options.
2. Press + or - until Error Log (Ultrium 232, Ultrium 448 and Ultrium 960) or View Event
Log (all other models) displays on the LCD screen. The LCD screen also displays the errors and
events currently stored in the log. Press Enter to access the most recently logged event.
NOTE: The event log with the Ultrium 232, Ultrium 448 and Ultrium 960 Tape Autoloaders
also includes a datestamp for each event.
3. Press + or - to display each event in the log.
4. Press Cancel.
NOTE: The most recent entry is number 0, older entries are negative numbers.
Product revision
NOTE: This option is not applicable to the DLT VS80 Tape Autoloader.
For all Ultrium Tape Autoloaders and SDLT 320 Tape Autoloader, the Product Revision option
displays the drive and robotics firmware versions in decimal and hexadecimal format.
To use this option:
1. From the Home screen or Main menu, press + or - until Information displays on the top line
of the LCD screen. Press Enter to access the available options.
2. Press + or - until Product Rev displays on the LCD screen. The LCD screen displays the
version of the drive and robotics firmware currently installed in the autoloader.
3. Press Cancel.