HP StorageWorks 1/8 Tape Autoloader User and Service Guide (August 2005)

Installing the autoloader14
Choosing a location
Choose a location that meets the following criteria:
Table 9 Location criteria
Criteria Definition
Standalone requirements Select a location that is flat, sturdy, level, and close to a host
server. Do not place the autoloader on the floor or other
carpeted surfaces.
Do not place the autoloader on its side, upside down, or stack
items on top of the autoloader.
Rack requirements Standard 19-inch rack with 2U of clearance
Room temperature 10-35º C (50-95º F)
Power source
AC power voltage: 100-127 VAC; 200-240 VAC
Line frequency: 50-60 Hz
Locate the AC outlet near the autoloader. The AC power cord is
the product’s main AC disconnect device and must be easily
accessible at all times.
Weight 26 lbs (12 kg)
Air quality
Minimal sources of particulate contamination. Avoid areas near
frequently used doors and walkways, stacks of supplies that
collect dust, printers, and smoke-filled rooms.
Excessive dust and debris can damage tapes and tape drives.
Humidity 20-80% RH non-condensing
Clearance Back Minimum of 15.4 cm (6 inches)
Front Minimum of 30.8 cm (12 inches)
Sides Minimum of 5.08 cm (2 inches)