HP StorageWorks All-in-One SB600c Storage Blade installation instructions (AG780-96002, September 2008)

Installing a storage and ser ver blade
IMPORTANT:
If your HP AiO SB600c Storage Blade is factory-integrated, the
server and storage blades are pre-installed in the enclosure.
CAUTION:
To prevent improper cooling and thermal damage, do not operate
the blade or the enclosure unless all ha rd drive and device bays
are populated with either a component or a blank.
The AiO SB600c consists of a server blade and storage blade. These
blades must be installed adjacent to one another in the enclosure as
a pair. In the figures below, the proper server blade / storage bla de
pairinstallationlocationsareshownasdevicebays1and2,3and4,
and so on.
1. Remo
ve the blank.
2. Prepare the storage blade for installation.
3. Install the storage blade.
4. Remove a blank from the adjacent device bay and repeat steps 2
through 3 to install the partner server blade.
Completing the configuration
To complete the HP BladeSystem enclosure configuration, see the
overview card that ships with the enclosure.
When the enclosure is powered on, the installed blades are also
powered on and the storage system installation process begins. The
installation process takes approximately 10–15 minutes and requires
no user interaction.
Page 3