HP StorageWorks 700ux/1100ux Optical Jukebox Service Manual (AA962-96004, September 2004)

Service Preparation
42 700ux/1100ux Optical Jukebox Service Manual
10. Install the shipping screws (see Figure 15):
a. Remove the two black, rubber plugs from the shipping screw holes on the left side of
the jukebox.
a. Remove the two white shipping screws from the storage holes on the back of the
jukebox. If these are not present, use the shipping screws from the replacement
jukebox.
b. Insert the shipping screws into the shipping screw holes.
c. Insert the rubber plugs into the storage holes.
Figure 15: Install the shipping screws
11. Secure the top panel to the jukebox using two T-10 Torx screws.
12. Remove the shipping screws and the top panel from the replacement jukebox.
13. Install the drives from the old jukebox into the new jukebox (see Installing an optical
drive, page 32).
14. If there is a configuration module, install it in the new jukebox (see Installing or replacing
the slot configuration module, page 37).
15. Power on the new jukebox.
16. Calibrate the picker.
a. If there is not a cartridge in slot 1 (SCSI element 31) use the LOAD* menu to load a
cartridge to that slot.
b. If necessary, press CANCEL to get to the READY mode.
c. Hold down the ENTER button and press PREV and NEXT so that all three are pressed at
the same time.
d. When <<MAINTENANCE>> PASSWORD>> displays, release the buttons.
e. Press ENTER, ENTER, NEXT.
f. Use NEXT or PREV to go to menu item 36: AUTO SLOT SET, then press ENTER.
g. When AUTO ADJUST TARGET : SLOT displays, press NEXT until DRIVE
displays, then press ENTER.
h. Wait until 36: AUTO SLOT SET displays. The calibration can take up to 10
minutes.
1 Black, rubber plugs
2 Storage holes
3 Shipping screw holes
4 Shipping screws
1
2
3
4