HP StorageWorks 700ux/1100ux Optical Jukebox Service Manual (AA962-96004, September 2004)

Service Preparation

35700ux/1100ux Optical Jukebox Service Manual

8. Secure the drive rails to the jukebox frame using two T-10 Torx screws (see Figure 10).

Figure 10: Install screws that secure drive rails to jukebox

9. Place the top panel on the jukebox and secure it using the two T-10 Torx screws removed

in step 2.

10. Power on the jukebox.

11. Calibrate the picker.

a. If there is not a cartridge in slot 1 (SCSI element 31) use the LOAD* menu to load a

cartridge to that slot.

b. If necessary, press CANCEL to get to the READY mode.

c. Hold down the ENTER button and press PREV and NEXT so that all three are pressed at

the same time.

d. When <<MAINTENANCE>> PASSWORD>> displays, release the buttons.

e. Press ENTER, ENTER, NEXT.

f. Use NEXT or PREV to go to menu item 36: AUTO SLOT SET, then press ENTER.

g. When AUTO ADJUST TARGET : SLOT displays, press NEXT until DRIVE

displays, then press ENTER.

h. Wait until 36: AUTO SLOT SET displays. The calibration can take up to 10

minutes.

i. Press NEXT to go to menu item 37: AUTO PUSH SET, then press ENTER.

1 Jukebox front

2 Drive 1

3 Drive 2

4 Drive rail (top side)

5 Screws that secure drive rail to jukebox (top side)

6 Drive rail (bottom side)