HP StorageWorks 700ux/1100ux Optical Jukebox Service Manual (AA962-96004, September 2004)

Service Preparation

32 700ux/1100ux Optical Jukebox Service Manual

Installing an optical drive

The following describes the procedure for upgrading from one optical drive to two optical

drives in the 700ux/1100ux Optical Jukebox.

Note: Before installing a new drive, obtain the most current version of the jukebox controller and

drive firmware for the model and option of the jukebox you are servicing.

Note: Online drive repair is not supported.

To install a second optical drive:

1. Power off the jukebox.

2. Remove the two T-10 Torx screws that secure the top panel to the jukebox and lift the top

panel off the unit.

3. Attach the rails (shipped with the kit) to the new drive, using two T-10 Torx screws (see

Figure 7).

Figure 7: Attach drive rails to the drive (right side of the drive is shown)

1 Right side of drive

2 Drive rails

3 Screws securing rails to drive