HP StorageWorks 700ux/1100ux Optical Jukebox Service Manual (AA962-96004, September 2004)

Service Preparation

30 700ux/1100ux Optical Jukebox Service Manual

12. Connect the cables to the drive (see Figure 6):

a. Connect the drive interface ribbon cable (the smaller of the two ribbon cables) to the

drive.

b. Connect the SCSI cable (the larger of the two ribbon cables) to the 68-pin connector.

c. Connect the power cable to the drive.

Note: Connect the left-most drive interface cable on the jukebox controller board to the left-most

drive, and the right-most drive interface cable on the jukebox controller board to the right-most drive.

Figure 6: Connect the cables to the drive

13. Slide the drive all the way into the jukebox so that the faces of the drive rails meet the

jukebox frame.

14. Secure the drive rails to the jukebox frame using two T-10 Torx screws (see Figure 3).

15. Place the top panel on the jukebox and secure it using the two T-10 Torx screws removed

in step 2.

16. Power on the jukebox.

17. Calibrate the picker.

a. If there is not a cartridge in slot 1 (SCSI element 31) use the LOAD* menu to load a

cartridge to that slot.

b. If necessary, press CANCEL to get to the READY mode.

c. Hold down the ENTER button and press PREV and NEXT so that all three are pressed at

the same time.

d. When <<MAINTENANCE>> PASSWORD>> displays, release the buttons.

e. Press ENTER, ENTER, NEXT.

f. Use NEXT or PREV to go to menu item 36: AUTO SLOT SET, then press ENTER.

1 Back of drive

2 Slot for power cable

3 Slot for SCSI cable (68-pin connector)

4 Slot for drive interface ribbon cable

5 Power cable

6 SCSI cable

7 Drive interface ribbon cable