HP StorageWorks 3800ux/7100ux Optical Jukebox Conversion Guide (AA991-96001, May 2004)

Convert an MO Jukebox to UDO or Mixed-Media Technology

313800ux/7100ux Optical Jukebox Conversion Guide

Install the drive modules

Install UDO drives in MO modules

To install UDO drives into MO modules:

1. Remove the MO drives from the existing MO modules.

2. Assemble the UDO drives into drive modules. For each drive:

a. Insert the drive into the sheet metal drive module.

b. Connect the cables to the drive and thread them through the holes in the module.

Note: Make sure you route the drive cables through the drive cable clamps.

c. Secure the drive to the module using two screws per side (supplied) on both sides of

the module.

d. Install and secure the cable access panel on the drive module.

3. For a 4-drive jukebox, insert the two UDO drive modules into place at drive locations 1/2

and 3/4 (see Figure 11).

Figure 11: Connection of drive cables and jumpers to the interposer board(s)

4. For a 6-drive or a 10-drive mixed-media jukebox, insert the three UDO drive modules into

place at drive locations 5/6, 3/4, and 1/2, in this order.

5. For a 10-drive UDO-only jukebox, insert the drive modules in all locations except 5/6.

Locations 5/6 are to remain empty in this configuration.

6. Secure the UDO drives to the jukebox using 2 T-20 torx screws, 1 on each side of each

drive.

1 Drive location 1/2

2 Drive location 3/4

3 Drive location 5/6

4 Drive location 7/8

5 Drive location 9/10

6 Drive location 11/12

7 Drive cables

8 Jumper location