HP StorageWorks 3800ux/7100ux Optical Jukebox Conversion Guide (AA991-96001, May 2004)

Convert an MO Jukebox to UDO or Mixed-Media Technology

26 3800ux/7100ux Optical Jukebox Conversion Guide

d. Locate the black self-adhesive strip that shipped with the kit and remove the backing

to expose the adhesive.

e. Position the LVD SCSI cable for the lower interposer board so that it is aligned

vertically with the LVD SCSI for the upper interposer board. Push the lower interposer

board’s cable up slightly so that it forms a curve between the connector and the

jukebox frame (see Figure 7).

Figure 7: Secure the upper interposer LVD SCSI cable to the jukebox frame

f. Use the black self-adhesive strip to secure the LVD SCSI cable to the jukebox frame

approximately one inch below the SCSI connector (see Figure 7).

Note: Ensure that there is at least 1 inch (25 mm) of the black self-adhesive strip on either side of the

LVD SCSI cables, and that the distance between the SCSI connector and the top of the strip is at least

7/8 inch (22 mm). This is necessary for proper fit of the middle access panel.

1 Upper interposer board

2 LVD SCSI cable for lower interposer board

3 Black self-adhesive strip