HP StorageWorks 3800ux/7100ux Optical Jukebox Conversion Guide (AA991-96001, May 2004)

Convert an MO Jukebox to UDO or Mixed-Media Technology
253800ux/7100ux Optical Jukebox Conversion Guide
Install new interposer board(s)
To install the new interposer board(s):
1. Install the upper interposer board.
a. Align the upper interposer board in its proper location (see Figure 1, page 16).
b. Connect the interposer board to the jukebox frame using 8 T-20 torx screws.
c. Clean the chassis in the (vertical) area where the LVD SCSI cables will be routed from
the buffer board(s) to the interposer board(s).
d. Connect the appropriate LVD SCSI cable from the buffer board to the the upper
interposer board (see Figure 6).
Figure 6: Secure the upper interposer LVD SCSI cable to the jukebox frame
e. Locate the black self-adhesive strip that shipped with the kit and remove the backing
to expose the adhesive.
f. Position the LVD SCSI cable exactly vertical, or slightly to the right of vertical from
the upper interposer board to the buffer board. Maintain this alignment until the cable
is secured to the library frame.
g. Use the black self-adhesive strip to secure the LVD SCSI cable to the jukebox frame
between the bottom two sets of PEMs standoffs for the lower interposer board (see
Figure 6).
This strip will be covered by the lower interposer board, if one is installed.
h. Connect the interposer board power cables.
i. If appropriate, install the configuration module to the upper interposer board (see
Figure 2, page 19).
2. For a 10-drive jukebox, install the lower interposer board.
a. Align the lower interposer board in the location for the lower interposer board.
b. Connect it to the jukebox frame using 8 T-20 torx screws.
c. Connect the appropriate LVD SCSI cable from the buffer board to the lower interposer
board (see Figure 6).
1 Upper interposer board
2 LVD SCSI cable for upper interposer board
3 PEMs standoffs for lower interposer board
4 Black self-adhesive strip
1
2
4
3
3