HP StorageWorks 3800ux/7100ux Optical Jukebox Conversion Guide (AA969-96003, May 2004)

Installation
26 HP StorageWorks 3800ux/7100ux Optical Jukebox Setup Guide
■ Active bus indicator—Lit when the SCSI bus is active.
■ SCSI ports—68-pin high-density SCSI connectors (Micro D-type). Used for
attaching the SCSI cable from the jukebox to the host computer. One port
must have a SCSI cable connected, and the other must have a SCSI terminator
connected to it.
■ Power cord clip—Used to route the power cord away from other connectors
and provide strain relief for the power cord connection.
■ Product serial number label—Needed for service calls. Write down your
jukebox serial number before you call your service representative.
■ Access panel and mounting screws—Covers the interface and power
connection components. The panel is secured by two screws on the lower
corners.
Note: Two screws secure the customer access panel to the side of jukebox during
shipment from the factory. These screws are removed during unpacking but
should be replaced after installation is complete. If the jukebox is ever reshipped,
these screws must be in place to properly secure the access panel.
■ Cable access hole—Used to pass SCSI and power cables through the cabinet
to the inside of the jukebox.
■ Power switch—Turns power to the jukebox on and off.
■ Power receptacle—Used for connecting the power cord to the jukebox.
Located on the bottom of the power distribution assembly.