HP StorageWorks 30ux Standalone UDO Drive Setup Guide (AA961-96002, May 2004)

Installation

21HP StorageWorks 30ux Standalone UDO Drive Setup Guide

Back panel features and descriptions

Figure 4: Back panel features

■ SCSI ID switch—Used to set the SCSI ID.

Note: Be careful not to inadvertently change the SCSI ID when handling the standalone

UDO drive.

■ Power connector—Connection for the power cord.

■ Power switch—Turns power to the standalone UDO drive on and off.

■ SCSI port with terminator —68-pin high-density SCSI connector (Micro

D-type). Cable may be attached to either connector.

■ SCSI port with SCSI cable—68-pin high-density SCSI connector (Micro

D-type). Terminator may be attached to either connector.

1 SCSI ID switch

2 Power connector

3 Power switch

4 SCSI port with terminator

5 SCSI port with SCSI cable