HP StorageWorks 30ux Standalone UDO Drive Setup Guide (AA961-96002, May 2004)

Installation
19HP StorageWorks 30ux Standalone UDO Drive Setup Guide
The components listed in Table 4 are not supplied with the standalone UDO drive,
but are needed for operation.
Table 4: Needed components
Component Description
SCSI cable High-density 68-pin (Micro D) connector
for low-voltage differential interfaces
Host Bus Adapter (HBA) Low-voltage differential SCSI (LVDS) with
a free address for each drive. A
single-ended (SE) HBA can be used with
this LVDS device. However, to ensure
optimum performance, HP recommends
using an LVDS HBA to take advantage of
higher data transfer rates. If an SE HBA
is used, the maximum cable length will
be limited to 3 meters.
Note: If the drive is placed on a bus
with an SE peripheral, the bus will run in
SE mode even if the HBA is LVDS.
Power cord Localized power cord as required