2300ux Optical Jukebox Conversion Guide (AA994-96001, May 2004)

Completing the Conversion

411000ux/1900ux/2300ux Optical Jukebox Conversion Guide

Finishing the firmware upgrade

To finish the firmware upgrade:

1. Power on the jukebox, if necessary, and wait for the power on sequence to complete.

The front panel displays the jukebox status. It should display READY, but may still display

DEVICE FAILED.

2. Select ADMIN* > CONF* on the control panel, then use the NEXT key until you see

RESTORE DEFAULTS in the display.

3. Press ENTER to select RESTORE DEFAULTS, then wait until WAIT FOR UPDATE is no

longer shown.

4. Connect to a host running L&TT, if necessary.

a. Power off the jukebox.

b. Connect to the jukebox the computer which hosts L&TT.

c. Power on the jukebox.

Note: READY should display once the jukebox has completed its power on procedure. If DEVICE

FAILED displays instead, check to be certain that the hardware is correctly installed and repeat

these procedures until READY displays.

5. Power off and on the jukebox (you must do this a second time even if you performed the

previous step).

6. When the jukebox displays READY, run L&TT to ensure that the jukebox and all drives are

found.

Note: If L&TT does not recognize all of the drives, check that the cabling is installed correctly and

repeat these procedures until all drives are found.

7. If necessary, upgrade the firmware for all of the drives using L&TT.

8. The jukebox firmware should already be up-to-date. If it is not, update it now.

Note: If you did not download the UDO jukebox firmware first, you may have to disconnect all

drives, download jukebox firmware, connect drives, and download drive firmware again.

9. Verify proper jukebox operation:

a. Check for proper drive operation by running a “random write and verify” for

approximately 2 minutes.

b. Using a new disk or a re-writable with unneeded data, check for proper jukebox

operation by running the “wellness test.”

10. Enter any customer configurations that are different from the default using the CONF*

menu.