2300ux Optical Jukebox Conversion Guide (AA994-96001, May 2004)

Converting an MO Jukebox to UDO or Mixed-Media Technology

34 1000ux/1900ux/2300ux Optical Jukebox Conversion Guide

Replacing the controller board and cover

To replace the controller board and cover:

1. Place the controller board in its previous location, using the locator pins to ensure the

correct placement of the board (see Figure 6, page 20).

2. Connect to the controller board the seven cables previously disconnected.

3. Secure the controller board to the jukebox frame using the 7 T-20 screws. Remember that

one of the screw holes is located on the heat sink.

Caution: Avoid screwing into or through the cables under the controller board as you are

securing it to the frame.

4. Place the controller board cover in its previous location (see Figure 5). Be sure not to

pinch any cables with the controller board cover.

5. Secure the cover to the frame using the 4 T-20 screws.

Caution: Avoid screwing into or through the cables under the controller board cover as you

are securing it to the frame. Also avoid pinching the cables with the controller board cover

itself.

6. Clean the jukebox frame in the area of the terminator of the 50-pin single ended SCSI

cable.

7. Expose the double-sided tape on the terminator of the 50-pin single ended SCSI cable and

use the tape to attach the terminator to the jukebox frame.