2300ux Optical Jukebox Conversion Guide (AA994-96001, May 2004)

Converting an MO Jukebox to UDO or Mixed-Media Technology

30 1000ux/1900ux/2300ux Optical Jukebox Conversion Guide

6. The pre-existing folds in the cable lead the cable to the right, then to the right again. The

terminated end of the cable leads toward the front of the jukebox (see Figure 15).

Figure 15: Route for single-ended SCSI cable

7. Clean the chassis where the tape will go (see Figure 15).

8. Ensure that the cable is not on top of any screw holes and secure the cable to the floor of

the jukebox using the large, black tape strip provided (see Figure 15).

Finishing routing the new ribbon cables

To finish routing the new ribbon cables:

1. Clean the left side of the jukebox frame between the upper (vertical) slot and the lower

(horizontal) slot.

2. Thread the new ribbon cables up and through the upper (vertical) slot (see Figure 16) in

the following order, making sure to fold the ribbon so that it lays flat against the jukebox

frame:

a. Single-ended SCSI cable

b. GPIO cable

c. 68-pin SCSI ribbon cable

Caution: The edges of the upper slot are sharp. Be careful not to cut yourself or the cables.

1 Single-ended SCSI cable coming from the

interposer board

2 Folds in the single-ended SCSI cable

3 Terminated end of single-ended SCSI cable