2300ux Optical Jukebox Conversion Guide (AA994-96001, May 2004)

Converting an MO Jukebox to UDO or Mixed-Media Technology

26 1000ux/1900ux/2300ux Optical Jukebox Conversion Guide

Installing the new ribbon cables

This phase of the conversion process must be done in the following order, so that the new

cables can reach the proper ports on the new interposer board.

1. Route the orange and white 68-pin SCSI cable.

2. Route the 50-pin general purpose input-output (GPIO) cable.

3. Route the 50-pin single-ended SCSI cable.

The location of the part number labels on each cable is shown in Figure 11.

Figure 11: Labels on new ribbon cables

1 68-pin SCSI cable

2 50-pin GPIO cable

3 50-pin single-ended SCSI cable

4 Part number labels

5 “Interposer” labels