2300ux Optical Jukebox Conversion Guide (AA994-96001, May 2004)

Converting an MO Jukebox to UDO or Mixed-Media Technology

24 1000ux/1900ux/2300ux Optical Jukebox Conversion Guide

Removing the ribbon cables and the interposer board

Caution: Parts can be damaged by electrostatic discharge. Keep parts in their containers

until needed. Ensure you are properly grounded when touching static-sensitive components.

To remove the ribbon cables and the interposer board:

1. Open the two large plastic cable clamps on the bottom and back of the frame (see

Figure 9).

2. Remove the GPIO cable and SCSI cable that run through the jukebox and connect to the

interposer board. As you do so, remove the cable restraint straps and cable clips along the

length of the cables.

Figure 9: Cable clips on jukebox frame

3. Disconnect the GPIO and SCSI cables from the interposer board.

4. If the jukebox has a configuration module, remove it from the interposer board and set it

aside for later use. Remove all other cables from the interposer board.

1 Plastic cable clamps to remain 2 Existing cables to remove