2300ux Optical Jukebox Conversion Guide (AA994-96001, May 2004)

Converting an MO Jukebox to UDO or Mixed-Media Technology

191000ux/1900ux/2300ux Optical Jukebox Conversion Guide

Removing the controller board

Caution: Parts can be damaged by electrostatic discharge. Keep parts in their containers

until needed. Ensure you are properly grounded when touching static-sensitive components.

To remove the controller board:

1. Slowly raise the picker to the top of the jukebox manually.

2. Block the picker’s downward movement by inserting a screwdriver into the hole at the

back of the vertical motor gear box (see Figure 4).

Note: Figure 4 is a cutaway view of the jukebox from the left side. This side is not open, so you must

reach in from the right side of the jukebox and locate the vertical motor gear box on your right. The

front of the gear box, where you insert the screwdriver, faces away from you.

Figure 4: Block picker using a screwdriver

1 Picker

2 Vertical motor gear box

3 Screwdriver