HP StorageWorks 1500 Modular Smart Array maintenance and service guide (356606-002, October 2006)

FCC (Federal Communications Commission)
Class A Equipment, compliance notice,109
Class B Equipment, compliance notice,109
declaration of conformity,110
modifications,110
notice,109
Federal Communications Commission. See
FCC,109
Fibre Channel I/O module
replacing,85
fibre channel I/O module
LEDs,27
figures
LEDs
controller,23
fibre channel 1/0 module,27
firmware
cloning,103
cloning in redundant configurations,71
updating,103
floor mats, dissipating,114
G
German noise declaration,112
ground strap specifications,114
grounding
methods,64
methods,113
procedures,64
straps, wearing,114
suggested equipment for, 114
H
hard drive
blank, removing,74
blank, replacing,74
ejector levers,75,77
latches,75,77
LEDs
amber,24
recognizing,77
reconstructing,77
removing,75
removing in fault-tolerant systems,75
securing,77
hard drive firmware
updating,107
hazardous conditions
symbols on equipment,65
heel straps, using, 114
help
obtaining,11
hot-pluggable parts, MSA,69
HP
address for
FCC questions,110
series number, 110
technical support,11
telephone number
FCC questions,110
I
IEC EMC, worldwide regulatory compliance
notice,110
illustrated parts breakdown,13
indicators
fan module,28
informational messages
array controller restarting,53
array controller temperature ok,53
beacon off,53
beacon on ,52
cache batteries low, recharging,46
cache disabled no configuration,46
cache hardware enabled,45
cache hardware temporarily disabled,46
cache module # MB,45
configured volumes,51
EMU flash done,55
EMU flash started,55
fibre subsystem link ok,58
firmware flash done,55
firmware flashdoneonbox#,55
firmware flash started,55
firmware flash started on box #,55
firmware version,37
hard drive hot added box bay,48
hard drive hot removed box bay,48
hard drive position change detected,48
hard drive position charge invalid,48
initializing fibre subsystem,57
initializing PCI subsystem,57
initializing redundancy support,41
initializing SCSI subsystem,39
initializing subsystem,39
MSA1000 active controller,44
MSA1000 standby controller,44
new volume(s) detected,51
no volumes detected,51
non-compaq hard drive,48
obsolete cache data deleted,46
online upgrade complete,39
online upgrade fl ashing done,39
online upgrade flashing firmware,39
online upgrade flashing started,39
online upgrade redundancy halted,39
online upgrade restarting system,39
persistent mem disabled,59
persistent mem enabled,59
recovery ROM autoflash done,54
recovery ROM autoflash started,53
redundancy active active controller,41
118