HP StorageWorks 1500 Modular Smart Array Installation Guide (355901-004, October 2006)

Configuration Procedures - Linux Environments
76 HP StorageWorks 1500 Modular Smart Array Installation Guide
e. Install the System Management Homepage by entering:
rpm -ivh <SMH_rpm_filename>
(Where
<SMH_rpm_filename> is the name of the System Management
Homepage rpm.)
8. To install the Array Configuration Utility (ACU):
Note:
■ You must remove earlier versions of the ACU before installing later versions.
■ You must install the HP System Management Homepage before installing the ACU.
■ For information about using the ACU or the ACU-CLI, see ACU online help or the
HP Array Configuration Utility User Guide.
a. Navigate to the /ACU/Linux/x86 directory on the CD.
b. List the contents of the directory and identify the ACU installation rpm
file for your environment.
c. Install the ACU by entering:
rpm -ivh <ACU_rpm_filename>
(Where
<ACU_rpm_filename> is the name of the ACU rpm.)
Note: Warning messages regarding driver version dependencies may be displayed.
These messages do not affect the MSA and may safely be ignored.
d. Start the ACU by entering one of the following commands:
— To enable remote access, enter:
/usr/sbin/cpqacuxe -R
— To disable remote access, enter: /usr/sbin/cpqacuxe -d
9. To install the Array Configuration Utility - Command Line Interface:
a. Navigate to the /HPACUCLI/Linux directory on the CD.
b. List the contents of the directory and identify the directory for your
processor type.
c. Change to the CD directory for your processor type and list the contents
of the directory.