HP StorageWorks Storage Mirroring Recover Scripting Guide (T5437-96022, November 2010)

Snapshot Delete
Command
SNAPSHOT DELETE
Description
Deletes the specified snapshot(s) from the target
Syntax
SNAPshot DELete <con_id> <snapshot_list_number | ALL | OLD [
GOOD | BAD ] > [ON <target>]
Options
l con_id—Connection ID assigned to the source/target connection
l snapshot_list_number—The snapshot number retrieved from the
SNAPSHOT LIST command
l ALL—Deletes all snapshots
l OLD—Deletes only the oldest snapshot
l GOOD—If specified, deletes only good snapshot. If used with ALL, all
good snapshots will be deleted. If used with OLDEST, only the oldest
good snapshot will be deleted.
l BAD—If specified, deletes only bad snapshots. If used with ALL, all
bad snapshots will be deleted. If used with OLDEST, only the oldest
bad snapshot will be deleted.
l target—Name of the target, an IP address on the target, or a virtual IP
address
Examples
l snapshot delete 1 3
l snapshot delete 1 all bad
l snap del 1 oldest
Notes
l Snapshots are labeled as good or bad depending on the state of the
target at the time the snapshot was taken.
l Target names that contain non-alphanumeric characters must be
enclosed in quotation marks.