HP Storage Essentials V5.1 Installation Guide Second Edition (Linux Release) (T4283-96055, November 2006)

Installing the CIM Extension for SUSE and Red Hat Linux186
• For 64-bit Linux Itanium Servers:
# rpm -idvh APPQcimeIa64.rpm
• For all other servers:
# rpm -idvh APPQcime.rpm
The installation is done when you are returned to the command prompt.
Starting the CIM Extension Manually
The management server can only obtain information from this host when the CIM Extension is
running.
Keep in mind the following:
• You must have root privileges to run the CIM Extension. The CIM Extension only provides the
information within the privileges of the user account that started the CIM Extension. Only root
has enough privileges to provide the information the management server needs. If you do not
start the CIM Extension with root privileges, the management server will display messages
resembling the following: Data is late or an error occurred.
• To configure UNIX CIM Extensions to run behind a firewall, see ”Configuring UNIX CIM
Extensions to Run Behind Firewalls” on page 309.
To start the CIM Extension, type the following in the /opt/APPQcime/tools directory, where /opt is
the directory into which you installed the CIM Extension:
# ./start
The following is displayed:
Starting CIM Extension for LINUX...
Keep in mind the following:
• When you start the CIM Extension, you can change the port number the CIM Extension uses.
See ”Configuring CIM Extensions” on page 186 for more information.
How to Determine if the CIM Extension Is Running
You can determine if the CIM Extension is running by entering the following command at the
command prompt:
# ./status
The CIM Extension is running when the following message is displayed:
CIM Extension Running: Process ID: 93
where 93 is the process ID running the CIM Extension
Configuring CIM Extensions
Configuration information is stored in a configuration text file that is read by the CIM Extension on
start-up. The file is named cim.extension.parameters and is located in the
[Installation_Directory]/conf directory on the host. This directory also contains a file
named cim.extension.parameters-sample. This file contains samples of available