Brocade Access Gateway Administrator's Guide v7.1.0 (53-1002743-01, March 2013)

Access Gateway Administrator’s Guide 33

53-1002743-01

D_Port support

Saving port mappings

Before configuring D_Ports, you must remove all mappings between the subject ports and device

as they will not be retained. This includes port (N_Port to F_Port), device (WWN), static, and

dynamic mapping. You can save N_Port mappings using Fabric OS commands. Once you save the

mappings, you can display them so that you can manually reconfigure them after the D_Port is

disabled. A command is also available to delete saved N_Port mappings. The following are

available backup mapping commands. For more details, refer to the Fabric OS Command

Reference.

• To save configured N_Port mappings, enter the following command:

ag --backupmappingsave N_Port

• To display saved N__Port mappings so that you can reconfigure them on the switch, enter the

following command:

ag --backupmappingshow N_Port

Following is an example of command output:

sw0:root>ag --backupmappingshow 44

Configured static and prefered mappings haved been saved for the N_port

successfully

N_Port 44

Backed-up Configured F_Ports 20:21:22

Backed-up Static F_Ports 23:24

Backed-up Preferred F_Ports 26:27:28:29

• To delete configured N_Port mappings, enter the following command:

ag --backupmappingdel N_Port