HP Smart Update Manager 6.2.0 Release Notes (Ed. 2)

HP SUM Console mode displays an error when you add the localhost by IP address
Suggested Action: No action. When you add the localhost to HP SUM in console mode by IP address,
it displays an error adding the IP address. The localhost can only be added by specifying the name,
localhost.
HP SUM does not update firmware in offline mode when memory is greater than 1 terrabyte
Suggested Action: No action necessary. This will be resolved in a future version.
HP SUM displays a return code of 6 for Flash Backed Write Cache for B-Series Smart Array firmware
Suggested Action: If the return code is 6, HP SUM cannot update this component. No action necessary.
HP SUM displays “Update returned an error” when deploying the HP Fibre Channel Enablement Kit
for Linux
Suggested Action: View the update log. If you see the error Enablement kit is not supported
for the installed driver version, use the following instructions to work around this issue:
1. Install HBA drivers before installing the Enablement kit.
2. Make sure the driver and Enablement kit version match.
This known issue will be resolved in a future version.
HP SUM displays an error when it inventories WBEM and FCHBA components on VMware nodes
Suggested Action: No action. This indicates that the VMware WBEM provider might be stopped or
hung.
Deploying updates to OA and iLO nodes at the same time might cause a network issue
Suggested Action: Deploy updates to the iLO and OA through the OA node. HP SUM determines the
proper deployment order to minimize deployment issues. Alternatively, you can wait for HP SUM to
finish updating one node and then update the other node.
HP SUM unexpectedly shuts down after updating an Emulex node
Suggested Action: No action necessary. This will be fixed in a future version.
HP SUM displays an incorrect error for Emulex firmware
Suggested Action: No action necessary. This will be fixed in a future version.
HP SUM requires minimum versions of VC and OA to support HP Integrity nodes
Suggested Action: Verify that HP Integrity i2 OA versions are 3.30 and VC version 3.6, and HP Integrity
i4 servers are OA version 3.60 and VC version 3.70.
HP SUM does not deploy updates to a VC node that is managed by VCEM
Suggested Action: No action. Use VCEM to deploy updates to the VC node.
HP SUM stops responding during inventory on IPv6 networks
Suggested Action: Use IPv4 addresses for VC nodes. Use VCSU to update VC nodes if no IPv4 addresses
are available.
HP SUM does not inventory or deploy all nodes when you select multiple nodes when using the GUI
Suggested Action: Re-inventory or re-deploy on the nodes that did not finish. It is recommended that
you inventory or deploy 10 or fewer nodes at a time when using HP SUM at this time. This will be
resolved in the future version of HP SUM.
Issues and suggested actions 19