HP Serviceguard Toolkit for Integrity Virtual Servers User Guide

DescriptionAttributes
This attribute is used to indicate if the VM or vPar guest
package can run in maintenance mode. The default
value is [yes].
MAINTENANCE_FLAG
This is the time interval (in seconds) between the monitor
cycles and the default value is 30 seconds. The toolkit
MONITOR_INTERVAL
monitors the health of the package every
[MONITOR_INTERVAL ]seconds.
Name of the service that Serviceguard monitors while
the package is up. This name must be unique for VM
service_name
or vPar guest package in a Serviceguard cluster. The
default name for a VM and vPar package is vm_name
and vpar_name, respectively. When you use the
cmdeployvpkg command, <vm_name> or
<vpar_name> is added as the value of this attribute.
5. After the package configuration file is edited, save the file.
6. To validate the package configuration file, run the command:
cmcheckconf –P pkg.conf
7. To apply the package configuration file if the cmcheckconf command succeeds, run the
command:
cmapplyconf -P pkg.conf
Confirm if you want to modify the package configuration. The default value is [yes]
8. To enable auto run and package failover, run the following commands:
• $ cmmodpkg -e -n <node_1>...-n <node_n> <package name>
• $ cmmodpkg -e <package name>
9. To check the status of the package, run the command: cmviewcl.
Using SG IVS Toolkit commands
The cmdeployvpkg command assists you to create and manage Serviceguard package
configurations for HP Integrity VM and HP-UX vPars. This command automates the configuration
steps performed using the Serviceguard commands.
Run cmdeployvpkg -P <vm/vpar_name> [....] to configure the VM or vPar as a
Serviceguard package.
Before applying the configuration, you must review the generated package configuration file, to
ensure that correct logical volumes, mount points are identified and included in the package
configuration files.
The cmdeployvpkg command:
• Verifies the Serviceguard cluster environment.
• Verifies the VM or vPar environment.
• Identifies the Serviceguard modules and attribute values.
• Creates a Serviceguard package configuration file.
• Configures a set of HP Integrity servers grouped into a VM or vPar multi server environment.
After you run the cmdeployvpkg command, to package a guest containing CVM or CFS backing
store entries, review and modify the package configuration file.
For more information on cmdeployvpkg command, see the cmdeployvpkg(1) manpage.
16 Using SG IVS toolkit