HP Serviceguard Storage Management Suite Version A.02.01 for HP-UX 11iv3 Release Notes, Edition 2 (May 2010)

the installed bundle. Follow any special instructions included with the patches. Access to these
patches requires a valid support contract and login to the ITRC.
You can also search for individual patches on the Hewlett-Packard IT Resource Center (ITRC)
web site:
http://itrc.hp.com (Americas and Asia Pacific) http://europe.itrc.hp.com (Europe)
Patches can be superseded or withdrawn at any time, so always be sure to check the status of a
patch before downloading it.
Individual products included in an HP Serviceguard Storage Management Suite bundle or other
products installed on your system may require additional patches. This list is subject to change
without notice. Contact your HP support representative for up-to-the-moment information.
Table 1-7 Required or Recommended Patches and Associated Bundles
T
2
7
7
7
C
B
T
2
7
7
6
C
B
T
2
7
7
5
C
B
T
2
7
7
4
C
B
T
2
7
7
3
C
B
T
2
7
7
1
C
B
DescriptionPatch Number
Required Patches
XXXXXX11.31 Aries cumulative patchPHSS_36311
XXXXXX11.31 vm cumulative patchPHKL_37452
XXXX11.31 VRTS 5.0 GARP1 VRTSodm Kernel PatchPHKL_38241
XXXXXX11.31 VxVM 5.0 GARP2 Commands Patch 02PHCO_38412
XXXXXX11.31 VxVM 5.0 GARP2 Kernel Patch 02PHKL_38413
XXXXXX11.31 VRTS 5.0 GARP2 VRTSvxfs Kernel PatchPHKL_38574
Recommended Patches
XXXXXX11.31 Integrity Virtual Machine Capabilities InterfacePHKL_36261
XXXXXX11.31 Integrity Unwind LibraryPHSS_37040
XXXXXX11.31 libc cumulative patchPHCO_37127
XXXXXX11.31 vfs module patchPHKL_37296
XXXXXX11.31 linker + fdp cumulative patchPHSS_37493
XXXXXX
11.31 fs_wrapper patch
PHCO_37645
XXXXXX
11.31 cumulative patch for bcheckrc
PHCO_37807
Product Issues and Limitations
This section provides information on known issues and limitations for the HP Serviceguard
Storage Management Suite Version A.02.01 HP-UX 11i v3 bundles at the time of this release. For
the most recent information contact your HP support representative or the Hewlett-Packard IT
Resource Center.
Use of HP-UX mount Commands for CFS Environments
Once disk group and mount point multi-node packages are created with Serviceguard, it is critical
to use the CFS commands, including cfsdgadm, cfsmntadm, cfsmount, and cfsumount. If
the HP-UX mount and umount commands are used, serious problems such as writing to the
local file system instead of the cluster file system could occur.
38 HP Serviceguard Storage Management Suite Version A.02.01 for HP-UX 11i v3 Release Notes