HP Serviceguard Storage Management Suite Version A.02.01 for HP-UX 11iv3 Release Notes, Edition 2 (May 2010)

The process is straight forward for non-OE SG SMS bundles. Follow the steps in

“Installing HP Serviceguard Storage Management Suite” (page 30) for a SG SMS

—

installation from the SG SMS media (DVD). Then the HP-UX update can be done

independently using the HP-UX installation media (DVD).

— For SG SMS Operating Environment (OE) bundle upgrades, additional planning is

necessary. The SG SMS software provided on the SG SMS DVD relies on products and

filesets that are provided on the HP-UX OE (DCOE, or HAOE) DVD. If the new SG SMS

OE bundle version requires new versions of Serviceguard and ECMT that are delivered

on the HP-UX OE media, Serviceguard and ECMT must be updated together with the

SG SMS OE bundle upgrade (not with the HP-UX update). For the HP-UX update,

Serviceguard and ECMT are excluded from the update when you run the update-ux

command. For the SG SMS OE bundle upgrade, the appropriate (supported) versions

of Serviceguard and ECMT must be added to the software depot that the SG SMS OE

bundle will be upgraded from. See “Upgrading a SG SMS OE Bundle - Independent

from an HP-UX Update” (page 36) for more information.

Updating HP-UX and SG SMS Simultaneously

This section describes the process for updating the HP-UX version and the HP Serviceguard

Storage Management Suite Operating Environment (OE) bundle version in one step using

update-ux. This procedure is necessary when an upgrade to a new SG SMS OE bundle depends

on a later Serviceguard version than the one that is currently installed.

General information about updating to HP-UX 11i v3 with update-ux, is available at:

http://docs.hp.com/en/oshpux11iv3.html#Installing%20and%20Updating

1. Copy the contents of your 11i v3 OE media to an HP-UX depot, for example:

swcopy -s /11iv3OE_DVD \* @ /var/depots/my_hpux_depot

If there are multiple 11i v3 OE DVDs, repeat this with each DVD.

You can also use the interactive swcopy command to automatically mount and unmount

the DVD, for example:

swcopy -i \* @ /var/depots/my_hpux_depot

- then select Find Local CD-ROM in the Specify Source screen.

2. Copy the contents of the HP-UX Serviceguard and HP Storage Management Products media,

for example /11iv3SG_DVD, into the same HP-UX depot. If there are multiple Serviceguard

and Storage Management DVDs, repeat this with each DVD:

swcopy -s /11iv3SG_DVD \* @ /var/depots/my_hpux_depot

Or use interactive swcopy as shown in step 1.

3. If you plan to use this HP-UX depot to update systems other than the system where the

depot resides, the HP-UX depot must be registered. The swcopy command will automatically

it is visible to other systems. To do this, enter:

swreg -l depot @ /var/depots/my_hpux_depot

34 HP Serviceguard Storage Management Suite Version A.02.01 for HP-UX 11i v3 Release Notes