HP Serviceguard Storage Management Suite Version A.02.01 for HP-UX 11iv3 Release Notes, Edition 2 (May 2010)

Table 1-5 Supported SG SMS Bundle Upgrade Paths - HP-UX 11i v2 and HP-UX 11i v3 (continued)

A.02.01A.02.00A.02.00A.01.01A.01.00SG SMS Version

11i v311i v311i v211i v211i v2HP-UX Version

A.11.19A.11.18A.11.18A.11.18A.11.17Serviceguard

Version

5.05.05.04.14.1Veritas SF

Version

T8696CBR →T8696CB

DCOE w/ SG

SMS CFS Oracle

T8697CBR →T8697CB

DCOE w/ SG

SMS CFS RAC

1 The T2772xx bundle is no longer available, starting with the SG SMS version A.02.01 release. Use the T2774CB bundle

instead.

2 T2776xx bundle is no longer available as a “stand-alone” bundle starting with the SG SMS version A.02.01 release,

except when it is included as a component of the T8686CB HAOE bundle, or the T8696CB DCOE bundle. Use the

T2777CB bundle instead.

3 For any MCOE bundle T279xBA, T279xCA, or T279xCB, you can upgrade to the corresponding DCOE bundle

(T869xCB) for HP-UX 11i v3, without removing the MCOE bundle.

4 This is the initial release for the HAOE bundles.

5 This is the initial release for the DCOE bundles.

NOTE: If a newly installed bundle includes the same version of a product that was previously

installed and patched, the patches may need to be installed again.

NOTE: If there is a cluster configured on a node, the swremove command will not let you

remove SG SMS from that node. You must halt the node, remove the node from the cluster, and

then use swremove to remove SG SMS.

NOTE: The procedure for rolling or offline upgrades of SG SMS HAOE or DCOE bundles

requires additional steps. See “HP-UX Operating Environment Upgrade Limitations” (page 41)

for more information.

Disabling Cluster Auto-Start on Reboot

Before attempting a SG SMS bundle installation or upgrade, you must disable AUTOSTART_CMCLD.

To disable AUTOSTART_CMCLD on all cluster nodes, access the/etc/rc.cofig.d/cmcluster

file and set AUTOSTART_CMCLD to 0, (AUTOSTART_CMCLD=0).

To re-enable Automatic startup (AUTOSTART_CMCLD) after completing your SG SMS bundle

installation or upgrade, set the flag AUTOSTART_CMCLD to 1 in the /etc/rc.config.d/

cmcluster file (AUTOSTART_CMCLD=1)

For more information on AUTOSTART_CMCLD, see the Setting up Autostart Features and Performing

a Rolling Upgrade sections in Managing Serviceguard, Fifteenth Edition, available at http://docs.hp.com

> High Availability > Serviceguard.

Cluster Offline Upgrade Option for SG SMS Bundles Containing CVM/CFS

To upgrade a SG SMS CFS bundle (T2775xx, T2776xx, or T2777xx) where the supported upgrade

path in Table 1-5 (page 26) indicates an offline upgrade is required, there is a procedure that

may work with your configuration to minimize the time that the entire cluster is offline. This is

accomplished by performing an offline upgrade on half of the cluster nodes while the other half

of the cluster nodes remain online.

Compatibility Information and Installation Requirements 27