HP Serviceguard Storage Management Suite Version A.01.01 Release Notes, April 2008

HP Serviceguard Storage Management Suite Version A.01.01 Release Notes
Compatibility Information and Installation Requirements
Chapter 126
2. Install the HP Serviceguard Storage Management Suite bundle. For
bundles T2771BA, T2772BA, T2773BA, or T2774BA use the June
2007 HP-UX Application Software media. For bundles T2775BA,
T2776BA, or T2777BA use the HP-UX Serviceguard and Storage
Management Products media. Use the appropriate bundle product
number in place of T27xxBA. This installation will reboot the system
once:
swinstall -x autoreboot=true -s <depot> T27xxBA
The default setting for installation of the bundle is
“reinstall=false” this will preserve any existing installation of the
same version of a product.
3. After installation of software and one reboot is completed apply any
required product patches. During this initial reboot and until all
required patches are applied, various startup errors may be reported.
Patches required for use of the Serviceguard Storage Management
Suite are available from http://www.hp.com/go/sgsms/patches.
Follow any special instructions included with the patches. Download
the patches into a single file, extract the contents, and create a single
depot using instructions included with the download. Install the
patches using the option “patch_match_target=true”. This will
install only the patches from the depot that match the installed
bundle.
4. After installation of any required product patches is completed run
vxinstall. If vxinstall has already been run on these systems,
this step may be skipped. This procedure completes initialization
steps for the Veritas software prompting for Veritas licenses (use
default response - no), specification of default disk group, and the use
enclosure-based naming. For details on vxinstall, refer to Veritas
4.1 Installation Guide.
5. Verify a successful installation. Use the appropriate bundle product
number in place of T27xxBA: swverify T27xxBA
6. List components installed with: swlist
7. Repeat all steps for each node in the cluster.
8. Refer to Managing Serviceguard for details on configuring the
cluster. A high-level summary of the steps involved in using the
Cluster File System are: