Building Disaster Recovery Serviceguard Solutions Using Metrocluster with Continuous Access EVA P6000 for Linux B.01.00.00

Figure 5 Selecting Metrocluster module
5. You will be prompted next to include any other toolkit modules. In case, application being
configured has a Serviceguard toolkit, select the appropriate toolkit; otherwise, move to the
next screen.
6. Enter the package name. Metrocluster packages can be configured only as failover packages.
Make sure that this option is selected as shown in Figure 6 (page 23) and then click Next.
Figure 6 Configuring package name
7. Select additional modules if required by the application. For example, if the application uses
LVM volumegroups or VxVM diskgroups, select the volume_group module. Click Next.
Figure 7 Selecting additional modules for the package
8. Review the node order in which the package will start, and modify other attributes, if needed.
Click Next.
Figure 8 Configuring generic failover attributes
9. Configure the attributes for a Metrocluster package. All the mandatory attributes (marked with
*) must be accurately filled.
a. Select Application start up policy from the list.
b. Specify the DR Group name, and then enter values for Wait Time and Query Timeout ,
if required.
c. Select hosts for Data Center 1 and Data Center 2. Enter DC1/DC2 Storage World Wide
Names.
d. Specify the list of management servers for DC1 and DC2.
Installing and configuring an application 23