Serviceguard Version A.11.16 Release Notes, 2nd Edition, September 2004

Serviceguard Version A.11.16 Release Notes, Second Edition
Installing Serviceguard on HP-UX 11i v2
Chapter 1 29
Installing Serviceguard on HP-UX 11i v2
This section has directions for installing Serviceguard A.11.16 on HP-UX
11i v2 (uname -a = 11.23). To install on HP-UX 11i v1, see page 24
After you install HP-UX 11i version 2, use the swinstall command to
install Serviceguard, product number T1905BA. After installation, you
can use the following command to display a list of all installed
components:
# swlist -R T1905BA
NOTE The EMS-CORE fileset is no longer a component of Serviceguard, but it
is a dependency, which means that it must be present on the installation
media or depot when Serviceguard is installed. If you create your own
depots as a part of your installation process, be sure to include the
EMS-CORE fileset, which is part of the Event Monitoring Services
product (B7609BA).
Installation steps should be performed in the following order:
1. You need to have installed HP-UX 11i v2 (11.23) before loading
Serviceguard Version A.11.16.
2. Install your Serviceguard product — version A.11.16. The filesets
that make up the Serviceguard product are:
• Serviceguard.CM-SG
• Cluster-Monitor.CM-CORE
• Cluster-Monitor.CM-CORE-MAN
• Cluster-Monitor.CM-CORE-COM
• Package-Manager.CM-PKG
• Package-Manager.CM-PKG-MAN
NOTE There are files in CM-CORE that are reserved for HP support. Do not
change these files. Do not move, alter, or delete the following: