Serviceguard Version A.11.16 Release Notes, 2nd Edition, September 2004

Serviceguard Version A.11.16 Release Notes, Second Edition
Installing Software on HP-UX 11i v1
Chapter 128
De-Installing Serviceguard
To deinstall your software, run the SD-UX swremove command. Before
removing software, note the following:
1. Serviceguard must be halted (not running) on the node from which
the swremove command is issued.
2. The system from which the swremove command is issued must be
removed from the cluster configuration.
3. The swremove command should be issued from one system at a time.
That is, if Serviceguard is being deinstalled from more than one
system, it should be removed from one system at a time.
If your system is left with a zero-length binary configuration file
(/etc/cmcluster/cmclconfig), you should remove it.
4. Before doing an swremove of both the Serviceguard and the Event
Monitoring Service (EMS) products, make sure that all user-written
resource monitors are terminated.
NOTE When you remove Serviceguard from a system, the Event Monitoring
Service (EMS) is not automatically removed. If you intend to
re-install Serviceguard at a later time, or if you are installing a
different version of Serviceguard, you should check if this version of
Serviceguard requires a newer version of EMS, and if so, remove the
existing EMS version separately before re-installing Serviceguard.