Serviceguard Version A.11.16 Release Notes, 2nd Edition, September 2004

Serviceguard Version A.11.16 Release Notes, Second Edition
Installing Software on HP-UX 11i v1
Chapter 124
Installing Software on HP-UX 11i v1
Following are the directions for installing Servcieguard A.11.16 on
HP-UX 11i v2 (uname -a = 11.11). For instructions on installing on
HP-UX 11i v2, see page 29.
To install your software, run the SD-UX swinstall command. It will
invoke a user interface that will lead you through the installation.
Separate installation of Serviceguard is not necessary if you are
installing the Mission Critical Operating Environment.
After updating to HP-UX 11i v1, you may find that kernel memory is low
due to post 11i v1 software configuration. This can result in insufficient
memory to run Serviceguard commands, such as cmrunnode, after
Serviceguard A.11.16 is installed. To avoid problems, reboot the node
after the update has completed, then issue the cmrunnode command.
NOTE The EMS-CORE fileset is no longer a component of Serviceguard, but it
is a dependency, which means that it must be present on the installation
media or depot when Serviceguard is installed. If you create your own
depots as a part of your installation process, be sure to include the
EMS-CORE fileset, which is part of the Event Monitoring Services
product (B7609BA).
Installation steps should be performed in the following order:
1. You need to have installed HP-UX 11.11 before loading Serviceguard
Version A.11.16.
2. Install your Serviceguard product — version A.11.16. The filesets
that make up the Serviceguard product are:
• Serviceguard.CM-SG
• Cluster-Monitor.CM-CORE
• Cluster-Monitor.CM-CORE-MAN
• Package-Manager.CM-PKG
• Package-Manager.CM-PKG-MAN
• ATS-CORE.ATS-MAN