Managing Serviceguard Seventeenth Edition, First Reprint December 2009

• run_script_timeout and halt_script_timeout. Enter the number of seconds Serviceguard
should wait for package startup and shutdown, respectively, to complete; or leave
the default, no_timeout; see (page 266).
• successor_halt_timeout. Used if other packages depend on this package; see “About
Package Dependencies” (page 168).
• script_log_file (page 267).
• log_level (page 268).
• failover_policy (page 268). Enter configured_node or min_package_node.
(This parameter can be set for failover packages only.)
• failback_policy (page 269) Enter automatic or manual.
(This parameter can be set for failover packages only.)
• If this package will depend on another package or packages, enter values for
dependency_name, (page 269)dependency_condition, dependency_location, and optionally
priority.
See “About Package Dependencies” (page 168) for more information.
NOTE: The package(s) this package depends on must already be part of the
cluster configuration by the time you validate this package (via cmcheckconf(1m);
see “Verifying and Applying the Package Configuration” (page 293)); otherwise
validation will fail.
• To configure package weights, use the weight_name and weight_value parameters
(page 271). See “About Package Weights” (page 176) for more information.
• local_lan_failover_allowed. Enter yes to permit switching of the package IP address
to a standby LAN card on the local node, or no to keep the package address from
switching locally.
For multi-node packages, you must enter no.
• Use the monitored_subnet parameter to specify a subnet that is to be monitored for
this package. If there are multiple subnets, repeat the parameter as many times as
needed, on a new line each time.
In a cross-subnet configuration, configure the additional monitored_subnet_access
parameter for each monitored_subnet as necessary; see “About Cross-Subnet
Failover” (page 190) for more information.
• If this is a Serviceguard Extension for Oracle RAC (SGeRAC) installation, you can
use the cluster_interconnect_subnet parameter(page 273).
290 Configuring Packages and Their Services