Managing Serviceguard 13th Edition, February 2007

Planning and Documenting an HA Cluster
Package Configuration Planning
Chapter 4180
NOTE VxVM disk groups do not allow you to select specific
activation commands. The VxVM disk group activation
always uses the same command.
Leave the default setting or change it following the
directions in the control script template.
VXVOL
Controls the method of mirror recovery for mirrored
VxVM volumes.
Volume Groups
This array parameter contains a list of the LVM
volume groups that will be activated by the package.
Enter each VG on a separate line.
CVM Disk Groups
This array parameter contains a list of the VERITAS
CVM disk groups that will be used by the package (on
systems that support CVM; see “About VERITAS CFS
and CVM” on page 27). Enter each disk group on a
separate line, following the directions in the control
script template.
VxVM Disk Groups
This array parameter contains a list of the VERITAS
VxVM disk groups that will be activated by the
package. Enter each disk group on a separate line.
Logical Volumes, File Systems and Mount Options
These are array parameters, entered together as
triplets into array variables. Each triplet specifies a
filesystem, a logical volume, and a mount option string
for a file system used by the package. In the package
control script file, these variables are arrays, as follows:
LV, FS and FS_MOUNT_OPT.
On starting the package, the script may activate one or
more storage groups, and it may mount logical volumes
onto file systems. At halt time, the script unmounts the