Managing Serviceguard 12th Edition, March 2006

Configuring Packages and Their Services
Creating the Package Control Script
Chapter 6 297
#
# LV[1]=/dev/vg01/lvol2; FS[1]=/pkg01b; FS_MOUNT_OPT[1]=”-o rw”
# FS_UMOUNT_OPT[1]=””; FS_FSCK_OPT[1]=””; FS_TYPE[1]=”vxfs”
#
#LV[0]=””; FS[0]=””; FS_MOUNT_OPT[0]=””; FS_UMOUNT_OPT[0]=””;FS_FSCK_OPT[0]=””
#FS_TYPE[0]=””
#
# VOLUME RECOVERY
#
# When mirrored VxVM volumes are started during the package control
# bring up, if recovery is required the default behavior is for
# the package control script to wait until recovery has been
# completed.
#
# To allow mirror resynchronization to ocurr in parallel with
# the package startup, uncomment the line
# VXVOL=”vxvol -g \$DiskGroup -o bg startall” and comment out the default.
#
# VXVOL=”vxvol -g \$DiskGroup -o bg startall”
VXVOL=”vxvol -g \$DiskGroup startall” # Default
# FILESYSTEM UNMOUNT COUNT
# Specify the number of unmount attempts for each filesystem during package
# shutdown. The default is set to 1.
FS_UMOUNT_COUNT=1
# FILESYSTEM MOUNT RETRY COUNT.
# Specify the number of mount retrys for each filesystem.
# The default is 0. During startup, if a mount point is busy
# and FS_MOUNT_RETRY_COUNT is 0, package startup will fail and
# the script will exit with 1. If a mount point is busy and
# FS_MOUNT_RETRY_COUNT is greater than 0, the script will attempt
# to kill the user responsible for the busy mount point
# and then mount the file system. It will attempt to kill user and
# retry mount, for the number of times specified in FS_MOUNT_RETRY_COUNT.
# If the mount still fails after this number of attempts, the script
# will exit with 1.
# NOTE: If the FS_MOUNT_RETRY_COUNT > 0, the script will execute
# “fuser -ku” to freeup busy mount point.
FS_MOUNT_RETRY_COUNT=0
#
# Configuring the concurrent operations below can be used to improve the
# performance for starting up or halting a package. The maximum value for
# each concurrent operation parameter is 1024. Set these values carefully.
# The performance could actually decrease if the values are set too high