Managing Serviceguard 12th Edition, March 2006

Building an HA Cluster Configuration
Configuring the Cluster
Chapter 5226
Cluster Configuration Template File
The following is an example of an ASCII configuration file generated
with the cmquerycl command using the -w full option:
# **********************************************************************
# ********* HIGH AVAILABILITY CLUSTER CONFIGURATION FILE ***************
# ***** For complete details about cluster parameters and how to *******
# ***** set them, consult the Serviceguard manual. *********************
# **********************************************************************
# Enter a name for this cluster. This name will be used to identify the
# cluster when viewing or manipulating it.
CLUSTER_NAME cluster1
# Cluster Lock Parameters
# The cluster lock is used as a tie-breaker for situations
# in which a running cluster fails, and then two equal-sized
# sub-clusters are both trying to form a new cluster. The
# cluster lock may be configured using either a lock disk
# or a quorum server.
#
# You can use either the quorum server or the lock disk as
# a cluster lock but not both in the same cluster.
#
# Consider the following when configuring a cluster.
# For a two-node cluster, you must use a cluster lock. For
# a cluster of three or four nodes, a cluster lock is strongly
# recommended. For a cluster of more than four nodes, a
# cluster lock is recommended. If you decide to configure
# a lock for a cluster of more than four nodes, it must be
# a quorum server.
# Lock Disk Parameters. Use the FIRST_CLUSTER_LOCK_VG and
# FIRST_CLUSTER_LOCK_PV parameters to define a lock disk.
# The FIRST_CLUSTER_LOCK_VG is the LVM volume group that
# holds the cluster lock. This volume group should not be
# used by any other cluster as a cluster lock device.
# Quorum Server Parameters. Use the QS_HOST, QS_POLLING_INTERVAL,
# and QS_TIMEOUT_EXTENSION parameters to define a quorum server.
# The QS_HOST is the host name or IP address of the system
# that is running the quorum server process. The
# QS_POLLING_INTERVAL (microseconds) is the interval at which
# Serviceguard checks to make sure the quorum server is running.
# The optional QS_TIMEOUT_EXTENSION (microseconds) is used to increase
# the time interval after which the quorum server is marked DOWN.