HP Serviceguard Version A.11.20 Release Notes, February 2014

Support for Veritas 5.1 SP1 on HP-UX 11i v3 Only
IMPORTANT: For information about patches required to support HP Storage Management Suite
(SMS) bundles see the HP Serviceguard Storage Management Suite Release Notes for your version
of the Storage Management Suite at http://www.hp.com/go/hpux-serviceguard-docs —> HP
Serviceguard Storage Management Suite A.04.xx (with 5.1 SP1 Veritas).
• Serviceguard A.11.20 on HP-UX 11i v3 with the April 2011 patches or later supports version
5.1 SP1 of Veritas VxVM, CVM, and CFS from Symantec.
• Serviceguard A.11.20 on HP-UX 11i v3 with the September 2010 patch or later supports
version 5.0.1 of Veritas VxVM, CVM, and CFS from Symantec, and not 5.0 and earlier.
NOTE: For more information about SMS support for version 5.1 SP1, see the HP Serviceguard
Storage Management Suite Version A.04.01 Release Notes at the address given above.
Easy Deployment
In the past you had two main choices for configuring a cluster: using Serviceguard commands, as
described in detail in chapter 5 of Managing Serviceguard, or using the Serviceguard Manager
GUI (or some combination of these two methods). As of Serviceguard A.11.20, there is a third
option, called Easy Deployment.
The Easy Deployment tool consists of three commands: cmpreparecl (1m), cmdeploycl
(1m), and cmpreparestg (1m). In addition, there is a new -N option to cmquerycl, which
you can use to obtain networking information for the cluster heartbeat. These commands allow
you to get a cluster up and running in the minimum amount of time. The commands:
• Configure networking and security (cmpreparecl (1m))
• Create and start the cluster with a cluster lock device (cmdeploycl (1m))
• Create and import volume groups as additional shared storage for use by cluster packages
(cmpreparestg (1m)).
See the manpages for more information on the commands.
See also “Cluster-wide Device Special Files (cDSFs)” (page 20).
Advantages of Easy Deployment
• Quick and simple way to create and start a cluster.
• Automates security and networking configuration that must always be done before you configure
nodes into a cluster.
• Simplifies cluster lock configuration.
• Simplifies creation of shared storage for packages.
Limitations of Easy Deployment
• Does not install or verify Serviceguard software.
• Requires agile addressing for disks. See “About Device Special Files (DSFs)” (page 32).
• cmpreparestg (1m) will fail if cDSFs and persistent DSFs are mixed in a volume group.
See “Cluster-wide Device Special Files (cDSFs)” (page 20) for more information about cDSFs.
• Does not configure access control policies.
• Does not install or configure firewall and related software.
• Does not support cross-subnet configurations.
• Does not configure packages.
18 Serviceguard Version A.11.20 Release Notes