HP Serviceguard Version A.11.20 Release Notes, April 2011

CAUTION:
• This release of Serviceguard requires 11i v3. If you are already running earlier versions of
Serviceguard and HP-UX, see “Upgrading from an Earlier Serviceguard Release” (page 43)
for more information.
• If you intend to use an alternate Quorum Server subnet “About the Alternate Quorum Server
Subnet” (page 30), and the new cluster will use an existing Quorum Server, make sure you
are running Quorum Server version A.04.00. If not, you must upgrade the before you proceed;
see “Quorum Server Upgrade Required if You Are Using an Alternate Address” (page 9).
1. Install or upgrade to HP-UX 11i v3 before loading Serviceguard Version A.11.20.
For information and instructions, see the HP-UX Installation and Update Guide for the target
release at http://www.hp.com/go/hpux-core-docs.
2. Use the swinstall command to install Serviceguard, product number T1905CA.
For more information about swinstall, see the swinstall(1M) manpage and the Software
Distributor Administration Guide for HP-UX 11i v2 or 11i v3.
3. Verify the installation. Use the following command to display a list of all installed components:
swlist -R T1905CA
The filesets that make up the Serviceguard product are:
• Serviceguard.CM-SG
• SGManagerPI.SGMGRPI
• SGWBEMProviders.SGPROV-CORE
• SGWBEMProviders.SGPROV-DOC
• SGWBEMProviders.SGPROV-MOF
• CM-Provider-MOF.CM-MOF
• CM-Provider-MOF.CM-PROVIDER
• Cluster-OM.CM-DEN-MOF
• Cluster-OM.CM-DEN-PROV
• Cluster-OM.CM-OM
• Cluster-OM.CM-OM-AUTH
• Cluster-OM.CM-OM-AUTH-COM
• Cluster-OM.CM-OM-COM
• Cluster-OM.CM-OM-MAN
• Package-CVM-CFS.CM-CVM-CFS
• Package-CVM-CFS.CM-CVM-CFS-COM
• Package-Manager.CM-PKG
• Package-Manager.CM-PKG-MAN
• Cluster-Monitor.CM-CORE
• Cluster-Monitor.CM-CORE-COM
• Cluster-Monitor.CM-CORE-MAN
42 Serviceguard Version A.11.20 Release Notes