HP Serviceguard Version A.11.18 Release Notes, September 2008
1. Serviceguard must be halted (not running) on the node from which the swremove
command is issued.
2. The system from which the swremove command is issued must be removed from
the cluster configuration. (If the node is not removed from the cluster configuration
first, swremove will cause the current cluster to be deleted.)
3. The swremove command should be issued from one system at a time. That is, if
Serviceguard is being de-installed from more than one system, it should be removed
from one system at a time.
If a zero-length binary configuration file (/etc/cmcluster/cmclconfig) is left
your system you should remove it.
Patches for this Version
The table below lists patches required or recommended for Serviceguard A.11.18 on
HP-UX 11i v2 or 11i v3.
In addition, a patch is needed to activate some of the new features described earlier in
this document; see “September 2008 Patch” (page 13) and (for information about an
additional patch to enable nested mounts on CVM and CFS) “Support for Veritas 5.0
on HP-UX 11i v2 and 11i v3” (page 25).
Before installing Serviceguard, you should also check the Hewlett-Packard IT Resource
Center web page for any new patch requirements:
http://itrc.hp.com (Americas and Asia Pacific)
http://europe.itrc.hp.com (Europe)
NOTE: One quick way to see which patches that have been applied to your system
is a command such as the following:
swlist -l patch | grep applied | more
For complete information, see the section “Which Patches Are on a System?” in the
Patch Management User Guide for 11.x Systems, at http://docs.hp.com: choose 11i
v2 or 11i v3 under Operating Environments and then choose Patch
Management.
Table 1-7
DescriptionPatch Number
Patch to enable online replacement of LAN cards on HP-UX 11i v3. Fixes
JAGag27186; see “JAGag27186 (SR8606472298): OLR of a LAN Card in SG
cluster fails on HP-UX 11i v3” (page 89).
PHNE_35894
HP–UX 11i v2 patch. Fixes JAGaf75382. See “JAGaf75382 (SR8606415528):
lan2 has an IPv6 address (fec0:0:0:f08::36) but not in config. file” (page 78).
PHNE_34671 (or later)
cumulative transport patch
Patches for this Version 77