HP Serviceguard Version A.11.18 Release Notes, September 2008

Installing Serviceguard on HP-UX
Dependencies
The following are required by Serviceguard. They are part of the HP-UX Base Operating
Environment:
• Open SSL, which includes the OPENSSSL-RUN and OPENSSL-LIB filesets.
• The EventMonitoring bundle, which contains the EMS-CORE and
EMS-CORE-COM filesets.
Installing Serviceguard
Serviceguard will automatically be installed when you install the HP-UX Mission
Critical Operating Environment (MCOE).
To install Serviceguard independently, follow these broad steps:
NOTE: This release of Serviceguard requires HP-UX 11i v2 or 11i v3. If you are already
running earlier versions of Serviceguard and HP-UX, see “Upgrading from an Earlier
Serviceguard Release” (page 75) for more information.
1. Install or upgrade to HP-UX 11i v2 or 11i v3 before loading Serviceguard Version
A.11.18.
For information and instructions, see the HP-UX Installation and Update Guide for
the target release at http://docs.hp.com: choose the target version of HP-UX
under Operating Environments and then choose Installing and
Updating.
2. Use the swinstall command to install Serviceguard, product number T1905CA.
For more information about swinstall, see the swinstall(1M) manpage and
the Software Distributor Administration Guide for HP-UX 11i v2 or 11i v3.
3. Verify the installation. Use the following command to display a list of all installed
components: swlist -R T1905CA
The filesets that make up the Serviceguard product are:
• Serviceguard.CM-SG
• SGManagerPI.SGMGRPI
• SGWBEMProviders.SGPROV-CORE
• SGWBEMProviders.SGPROV-DOC
• SGWBEMProviders.SGPROV-MOF
• CM-Provider-MOF.CM-MOF
• CM-Provider-MOF.CM-PROVIDER
• Cluster-OM.CM-DEN-MOF
• Cluster-OM.CM-DEN-PROV
Installing Serviceguard on HP-UX 73